m_customaccel_scale – the command sets the scale of acceleration build-up.If you use acceleration, we recommend you to experiment with this parameter to prevent very abrupt movements of the camera. The setting of the team is not limited but it sets the limit of mouse movement that restricts acceleration. 0 is default (acceleration is not limited). m_customaccel_max – the command sets the limit of acceleration.The higher the size of the command is, the faster acceleration is activated.ġ.05 – default recomended_linksģ – your mouse will be moving faster than usualĠ.5 – the mouse moves slowlier than usual. m_customaccel_exponent (0-6) – sets the speed that is necessary to move the mouse for the set acceleration to work ( if it is on by the corresponding commands).The more sensitivity is, the higher acceleration effect is. The faster you move the mouse (in any direction), the faster the camera movesĢ – the mode of acceleration in X-axis and Y-axis that can be scaled depending on the sensitivity settings m_yaw и m_pitchģ – in this setting, acceleration will depend on the sensitivity settings. m_customaccel (0/1/2/3) – the command turns one several options of acceleration.ġ – max acceleration.This group of the parameters is a bit difficult for understanding and is hardly ever used by players. Also the reverse may be turned on in the game settings: To do it, you need to enter m_pitch -0.022. The command m_pitch makes it possible to set the reverse of mouse movement in the Y-axis. m_pitch – changes the sensitivity Y-axis (up-down movement).1 has very high sensitivity, 0.001 is the lowest sensitivity. m_yaw – the command sets the sensitivity of the mouse in the X-axis (left-right movement).The setting is used in wide scale, however, it is more often used in the range 1.5-4. sensitivity (0.0001 - 10000000) – this command helps to change the mouse sensitivity.In this case the input is done with the mouse and the OS settings (acceleration, delay, sensitivity, reverse, etc) are ignored as the game settings are applied. m_rawinput (0.1) – the command turns on/off raw input.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |